Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Speaker Field Coil Question
#1

Looking to verify the DC Ohms of the Following Speakers

CATHEDRAL MODELS

Model 51 Philco 6 inch Speaker FIELD 2500 DC Ohms ??????

Model 80 Philco 6 Inch Speaker FIELD 1200 DC Ohms ???????

Would like to verify above readings on a know speaker.

Thanks
Bob T
#2

Hi Bob

Model 50 and 51 used speaker "P" - field coil 1140 ohms.

Model 80 used speaker P-5 (early production) or P-6 (later production) - field coil 1140 ohms.

Yes, you can substitute one for the other as both have the same ratings.

--
Ron Ramirez
Ferdinand IN
#3

Hi Ron

Thank You, that is good news as yes that was my intent .
I have a 551 someone put a 2500 Ohm Coil Speaker in.


Merry Christmas


Bob T




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Mrfixr55, its working now. I cleaned the switches and sockets with spray cleaner. Thanks for helping on this one.daveone23 — 06:26 PM
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM

[-]
Who's Online
There are currently 3930 online users. [Complete List]
» 1 Member(s) | 3929 Guest(s)
Avatar

>