Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

superior tv-11
#1

hey guys
I received this was recapped at one point was suppose to work but nope did not I reflowed solder to cap and resistor that come loose it worked only problem is line adjustment will not center will not gou past 30
their is a cap old one with red strip ? schematic say`s should be a 20k and 47k is this a resister never see this before

http://www.radiomuseum.org/r/superior_tu...tv_11.html
[Image: http://i1303.photobucket.com/albums/ag14...a4c03a.jpg]
[Image: http://i1303.photobucket.com/albums/ag14...61117b.jpg]
thanks sam
#2

Sam

do you have a sch? Or a link? that is, not a Radiomuseum one?
#3

Without researching the part number, I believe that item is a Federal Selenium Rectifier Diode.
#4

1159 is a good Federal selenium rectifier number.
Here's a manual, but it doesn't appear to match what's pictured:
http://bama.edebris.com/manuals/superior/tv11/

Carl
Northern Panhandle, WV
#5

hey guys
sorry morzh didn`t realized RM cut photo
I have same one carl put up thanks carl
it is a Federal Selenium Rectifier Diode 1159 but it dose not give any spec`s schematic says 20k
sam
#6

Sam,
The rectifier is marked 8Y1 on the schematic.
The item marked 20K is an adjustment pot.

Carl
Northern Panhandle, WV




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Mrfixr55, its working now. I cleaned the switches and sockets with spray cleaner. Thanks for helping on this one.daveone23 — 06:26 PM
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM

[-]
Who's Online
There are currently no members online.

>