Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Sherwood S-7900A
#22

C'mon, Mike, I know that isn't high voltage... Icon_rolleyes

I was making a comparison to a tube circuit, in which this secondary would be on the order of a few hundred volts instead of around 40 volts. You know, the rough equivalent to the B supply.

OK. The original film caps shall remain. But I will replace C170 and C171 with safety caps.

--
Ron Ramirez
Ferdinand IN


Messages In This Thread
Sherwood S-7900A - by Ron Ramirez - 06-25-2016, 07:17 PM
RE: Sherwood S-7900A - by Ron Ramirez - 06-25-2016, 07:21 PM
RE: Sherwood S-7900A - by Ron Ramirez - 06-25-2016, 07:23 PM
RE: Sherwood S-7900A - by Ron Ramirez - 06-25-2016, 07:26 PM
RE: Sherwood S-7900A - by Ron Ramirez - 06-25-2016, 07:29 PM
RE: Sherwood S-7900A - by Arran - 06-26-2016, 03:00 AM
RE: Sherwood S-7900A - by Ron Ramirez - 06-25-2016, 07:35 PM
RE: Sherwood S-7900A - by morzh - 06-26-2016, 10:46 AM
RE: Sherwood S-7900A - by Ron Ramirez - 06-26-2016, 04:29 PM
RE: Sherwood S-7900A - by KCMike - 06-26-2016, 05:20 PM
RE: Sherwood S-7900A - by Eliot Ness - 06-26-2016, 05:52 PM
RE: Sherwood S-7900A - by Ron Ramirez - 06-26-2016, 06:38 PM
RE: Sherwood S-7900A - by Ed Locker - 06-27-2016, 08:35 AM
RE: Sherwood S-7900A - by Ron Ramirez - 06-27-2016, 03:27 PM
RE: Sherwood S-7900A - by Arran - 06-28-2016, 03:15 AM
RE: Sherwood S-7900A - by Ron Ramirez - 06-28-2016, 06:55 PM
RE: Sherwood S-7900A - by Arran - 06-29-2016, 03:15 AM
RE: Sherwood S-7900A - by Ron Ramirez - 12-22-2016, 09:58 PM
RE: Sherwood S-7900A - by morzh - 12-22-2016, 10:31 PM
RE: Sherwood S-7900A - by Ron Ramirez - 12-22-2016, 11:09 PM
RE: Sherwood S-7900A - by morzh - 12-22-2016, 11:15 PM
RE: Sherwood S-7900A - by Ron Ramirez - 12-23-2016, 08:38 AM
RE: Sherwood S-7900A - by morzh - 12-23-2016, 09:12 AM
RE: Sherwood S-7900A - by Ron Ramirez - 12-23-2016, 03:25 PM
RE: Sherwood S-7900A - by rocketeer - 12-23-2016, 07:55 PM
RE: Sherwood S-7900A - by KCMike - 12-23-2016, 08:48 PM
RE: Sherwood S-7900A - by Ron Ramirez - 05-22-2018, 09:18 PM
RE: Sherwood S-7900A - by morzh - 05-22-2018, 10:06 PM
RE: Sherwood S-7900A - by Ron Ramirez - 05-23-2018, 05:06 AM
RE: Sherwood S-7900A - by morzh - 05-23-2018, 06:39 AM
RE: Sherwood S-7900A - by Ron Ramirez - 05-23-2018, 08:08 AM



Users browsing this thread: 5 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM
Philco 91 Speaker Replacement
Yes, I often have to substitute, then keep an eye out for an original. In the meantime, the radio is working and being e...RodB — 08:02 AM

[-]
Who's Online
There are currently no members online.

>