|
Philco model 50
01-15-2010, 06:00 PM
Thank you Ron for your reply. I have not replaced the backelite blocks or the metal can (i was hoping it would not be required) but it looks like this will be my next venture. As for the dual pot, I got it out of another model 50 (used for parts) and was tested by a reliable source. I want to thank you again, and I will carry on! May be in touch again as I progress.
« Next Oldest | Next Newest »
Messages In This Thread
Philco model 50 - by Guest - 01-15-2010, 03:08 PM
Re: Philco model 50 - by Ron Ramirez - 01-15-2010, 04:58 PM
Re: Philco model 50 - by Guest - 01-15-2010, 06:00 PM
Re: Philco model 50 - by Carl Travis - 01-15-2010, 10:53 PM
Re: Philco model 50 - by Guest - 01-16-2010, 12:09 PM
Re: Philco model 50 - by Guest - 02-09-2010, 05:14 PM
Re: Philco model 50 - by 7estatdef - 02-09-2010, 06:06 PM
Re: Philco model 50 - by Guest - 02-09-2010, 06:42 PM
Re: Philco model 50 - by 7estatdef - 02-10-2010, 02:42 PM
Re: Philco model 50 - by Joe Rossi - 02-11-2010, 11:23 AM
Re: Philco model 50 - by Guest - 02-12-2010, 12:52 PM
Re: Philco model 50 - by 7estatdef - 02-12-2010, 08:33 PM
Re: Philco model 50 - by Guest - 02-13-2010, 08:37 AM
Re: Philco model 50 - by Jim Berg - 02-13-2010, 12:35 PM
Users browsing this thread: 1 Guest(s) |
