01-17-2010, 06:55 PM
Hi Elrick,
What is the number of the cap on diagram? Generally speaking you should be fine. I'm a little surprised that it uses a 1kv cap as the chaiss voltage is about 250v. Sometimes you will find them in the plate circuit of the audio output stage as those caps need to be rated at the high volt + the audio voltage. The unsoldered wire though the tuning condenser is normal.
Terry
What is the number of the cap on diagram? Generally speaking you should be fine. I'm a little surprised that it uses a 1kv cap as the chaiss voltage is about 250v. Sometimes you will find them in the plate circuit of the audio output stage as those caps need to be rated at the high volt + the audio voltage. The unsoldered wire though the tuning condenser is normal.
Terry
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!
Terry
