Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 96 help please
#16

For voltage measure you can use this    http://www.nostalgiaair.org/pagesbymodel...013901.pdf
It will get you in the balllpark. (model 95 diagram)

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry


Messages In This Thread
Philco 96 help please - by KYNole - 05-27-2017, 05:13 PM
RE: Philco 96 help please - by Ron Ramirez - 05-27-2017, 06:06 PM
RE: Philco 96 help please - by klondike98 - 05-27-2017, 07:18 PM
RE: Philco 96 help please - by KYNole - 05-27-2017, 07:27 PM
RE: Philco 96 help please - by KYNole - 05-27-2017, 07:32 PM
RE: Philco 96 help please - by klondike98 - 05-27-2017, 07:51 PM
RE: Philco 96 help please - by Ron Ramirez - 05-27-2017, 07:55 PM
RE: Philco 96 help please - by KYNole - 05-27-2017, 08:12 PM
RE: Philco 96 help please - by morzh - 05-27-2017, 08:23 PM
RE: Philco 96 help please - by GarySP - 05-27-2017, 08:29 PM
RE: Philco 96 help please - by morzh - 05-27-2017, 08:47 PM
RE: Philco 96 help please - by KYNole - 05-27-2017, 09:15 PM
RE: Philco 96 help please - by Radioroslyn - 05-27-2017, 09:17 PM
RE: Philco 96 help please - by KYNole - 05-27-2017, 09:42 PM
RE: Philco 96 help please - by Radioroslyn - 05-27-2017, 10:07 PM
RE: Philco 96 help please - by Radioroslyn - 05-27-2017, 10:37 PM



Users browsing this thread:
[-]
Recent Posts
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM
Philco 91 Speaker Replacement
Yes, I often have to substitute, then keep an eye out for an original. In the meantime, the radio is working and being e...RodB — 08:02 AM

[-]
Who's Online
There are currently 3292 online users. [Complete List]
» 2 Member(s) | 3290 Guest(s)
AvatarAvatar

>