Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

A Philco 91 restore
#21

I would just trim the ends and reinstall the loop.

Steve

M R Radios   C M Tubes


Messages In This Thread
A Philco 91 restore - by klondike98 - 01-10-2017, 01:36 PM
RE: A Philco 91 restore - by sam - 01-10-2017, 01:57 PM
RE: A Philco 91 restore - by morzh - 01-10-2017, 02:09 PM
RE: A Philco 91 restore - by klondike98 - 01-10-2017, 02:48 PM
RE: A Philco 91 restore - by morzh - 01-10-2017, 03:49 PM
RE: A Philco 91 restore - by Radioroslyn - 01-10-2017, 11:55 PM
RE: A Philco 91 restore - by klondike98 - 01-11-2017, 08:08 AM
RE: A Philco 91 restore - by morzh - 01-11-2017, 12:20 PM
RE: A Philco 91 restore - by Ron Ramirez - 01-11-2017, 12:21 PM
RE: A Philco 91 restore - by morzh - 01-11-2017, 12:25 PM
RE: A Philco 91 restore - by klondike98 - 01-11-2017, 04:55 PM
RE: A Philco 91 restore - by Nathan Slingerland - 01-11-2017, 05:14 PM
RE: A Philco 91 restore - by klondike98 - 01-11-2017, 05:16 PM
RE: A Philco 91 restore - by klondike98 - 01-12-2017, 12:11 PM
RE: A Philco 91 restore - by Ron Ramirez - 01-12-2017, 12:20 PM
RE: A Philco 91 restore - by Radioroslyn - 01-12-2017, 12:45 PM
RE: A Philco 91 restore - by klondike98 - 01-12-2017, 01:12 PM
RE: A Philco 91 restore - by Mondial - 01-12-2017, 05:18 PM
RE: A Philco 91 restore - by klondike98 - 01-12-2017, 07:42 PM
RE: A Philco 91 restore - by klondike98 - 11-13-2017, 04:09 PM
RE: A Philco 91 restore - by Steve Davis - 11-13-2017, 04:56 PM
RE: A Philco 91 restore - by Radioroslyn - 11-13-2017, 06:04 PM
RE: A Philco 91 restore - by klondike98 - 11-13-2017, 07:12 PM
RE: A Philco 91 restore - by klondike98 - 11-16-2017, 03:15 PM
RE: A Philco 91 restore - by klondike98 - 11-09-2018, 04:02 PM
RE: A Philco 91 restore - by klondike98 - 11-11-2018, 05:50 PM
RE: A Philco 91 restore - by Ron Ramirez - 11-11-2018, 11:23 PM
RE: A Philco 91 restore - by klondike98 - 11-12-2018, 07:35 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Mrfixr55, its working now. I cleaned the switches and sockets with spray cleaner. Thanks for helping on this one.daveone23 — 06:26 PM
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM

[-]
Who's Online
There are currently 3894 online users. [Complete List]
» 1 Member(s) | 3893 Guest(s)
Avatar

>