03-11-2018, 06:40 PM
Power supply finished. Had to have a way to mount the caps in the can so I built the terminal board using the terminals taken off from the old caps. This was wired up, secured in the can and covered with the original wax. Solder connections on the reisitors may look questionable but are as the original and are secure. The exposed copper was so badly oxisidixed that solder would not flow. A couple of the connections I had to file down to clean copper and flow solder there since the original wiring had so little solder contact area. Now to start the radio itself. Don't know yet how much pot metal I'll run into but hopefully not too bad.
