|
Alignment tool for Philco 70A trimmer capacitors
01-30-2006, 02:26 PM
Use a plastic 3/8" diam. piece of tubing (hobby or craft shops) and heat up a 1/4" hex nut to "melt-in" an impression of the nut in one or both of the open ends.
Chuck Schwark, The Philco Repair Bench [Image: http://www.philcorepairbench.com/images/philog3tiny.gif] http://www.philcorepairbench.com
« Next Oldest | Next Newest »
Messages In This Thread
Alignment tool for Philco 70A trimmer capacitors - by Guest - 01-30-2006, 01:00 PM
RE: Alignment tool for Philco 70A trimmer capacitors - by klondike98 - 11-05-2013, 12:57 PM
RE: Alignment tool for Philco 70A trimmer capacitors - by Bob Andersen - 11-06-2013, 01:24 PM
RE: Alignment tool for Philco 70A trimmer capacitors - by Randy H. - 11-12-2013, 06:23 PM
RE: Alignment tool for Philco 70A trimmer capacitors - by klondike98 - 11-12-2013, 10:31 PM
RE: Alignment tool for Philco 70A trimmer capacitors - by N6MKC - 06-19-2018, 07:52 PM
RE: Alignment tool for Philco 70A trimmer capacitors - by Radioroslyn - 06-19-2018, 08:04 PM
RE: Alignment tool for Philco 70A trimmer capacitors - by radiodale - 07-19-2018, 10:37 PM
[No subject] - by Chuck Schwark - 01-30-2006, 02:26 PM
[No subject] - by Guest - 01-31-2006, 09:47 AM
[No subject] - by Chuck Schwark - 01-31-2006, 09:52 AM
[No subject] - by Guest - 01-31-2006, 04:30 PM
[No subject] - by n9vu - 02-06-2006, 10:25 PM
[No subject] - by Chuck Schwark - 02-06-2006, 10:36 PM
Re: Alignment tool for Philco 70A trimmer capacitors - by LASJayhawk - 12-18-2011, 10:48 PM
Re: Alignment tool for Philco 70A trimmer capacitors - by 7estatdef - 12-19-2011, 10:50 AM
Users browsing this thread: 1 Guest(s) |
