|
Philco Cabinet Feet
08-05-2018, 12:48 PM
Paul, I plan to make these available to other restorers. Right now it takes about an hour to make a set, so the cost would be fairly high. I plan to make some modifications to the lathe that will probably cut that time in half. If so, I should be able to get the price in the $12 to $14 range.
Steve M R Radios C M Tubes
« Next Oldest | Next Newest »
Messages In This Thread
Philco Cabinet Feet - by Steve Davis - 08-05-2018, 11:46 AM
RE: Philco Cabinet Feet - by Paul Philco322 - 08-05-2018, 11:51 AM
RE: Philco Cabinet Feet - by Steve Davis - 08-05-2018, 12:48 PM
RE: Philco Cabinet Feet - by Paul Philco322 - 08-05-2018, 01:31 PM
RE: Philco Cabinet Feet - by Nathan Slingerland - 08-05-2018, 02:53 PM
RE: Philco Cabinet Feet - by Electrothaumaturgist - 08-05-2018, 05:46 PM
RE: Philco Cabinet Feet - by Arran - 08-06-2018, 01:49 AM
RE: Philco Cabinet Feet - by Greggshere - 09-01-2018, 08:40 PM
RE: Philco Cabinet Feet - by fenbach - 06-12-2021, 11:42 AM
RE: Philco Cabinet Feet - by Steve Davis - 06-12-2021, 09:20 PM
RE: Philco Cabinet Feet - by radiorich - 11-11-2022, 06:07 PM
RE: Philco Cabinet Feet - by Steve Davis - 11-15-2022, 08:22 PM
RE: Philco Cabinet Feet - by radiorich - 11-15-2022, 10:50 PM
Users browsing this thread: 1 Guest(s) |
