Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Well, I finally got my tombstone!
#6

I haven't actually worked on a 610 since I was a teenager, and that was a 37-610J, one of the consoles . Back then all it needed was new electrolytics, and a tube, and it was good to go. I do have a lot of experience with the 37-61, 37-630, and 48-482 though, as well as other makes. I'll give you what advice I can when you ask, but Ron and the others here know even more than I do. They'll be of even greater help, I'm sure. I do look forward to watching your progress with it.


Messages In This Thread
Well, I finally got my tombstone! - by Jake Blake - 09-19-2019, 08:03 PM
RE: Well, I finally got my tombstone! - by mikethedruid - 09-19-2019, 09:18 PM
RE: Well, I finally got my tombstone! - by rdnzl - 09-21-2019, 08:37 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM
Philco 91 Speaker Replacement
Yes, I often have to substitute, then keep an eye out for an original. In the meantime, the radio is working and being e...RodB — 08:02 AM

[-]
Who's Online
There are currently 3994 online users. [Complete List]
» 2 Member(s) | 3992 Guest(s)
AvatarAvatar

>