05-31-2020, 04:14 PM
>It is quite confusing to know which terminal this would attach to and wondering if it may be the cause of the problem. I circled the wire on the attached schematic. I have also attached a pic showing the detached wire.
It could. The bottom of the coil is connected to the hv line thru #22 1K resistor. Other options are 23, and 47 (lower section). Something simple to do is measure the resistance from the chassis to each end of #22. The lower resistance determens which side of the resistor closer to the short. Measure w/the bs in the lower frequency position.
Happy Hunting!
It could. The bottom of the coil is connected to the hv line thru #22 1K resistor. Other options are 23, and 47 (lower section). Something simple to do is measure the resistance from the chassis to each end of #22. The lower resistance determens which side of the resistor closer to the short. Measure w/the bs in the lower frequency position.
Happy Hunting!
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!
Terry
