Need help ID'ing console ('29 Model 65?)

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Need help ID'ing console ('29 Model 65?)

rjm
Member

Posts: 70
Threads: 17
Joined: Jan 2006
City: Newbern State, Province, Country: Tennessee

#15

03-27-2006, 01:01 AM

I was just looking at schematics on this sight and on Nostalgia Air. Here and on theirs, show one set 65 w/ 1&2 as heater. 1 going to condenser. The other schematic 65-62 showing the same terminals, but # them 4 & 5. One shows #1 from trans to 80 heater then to cond. And the other shows #4 doing the same. Both are the same coil in the trans. You might have the 25hz. model 65-62. Check the schematics for that one, there is other differences too.

65-62, is the 25hz. model. and 65 is the 60hz. model.

Richard

Find

« Next Oldest | Next Newest »

Messages In This Thread

Need help ID'ing console ('29 Model 65?) - by noiseguy - 01-30-2006, 10:51 PM

[No subject] - by Chuck Schwark - 01-30-2006, 11:21 PM

[No subject] - by noiseguy - 01-31-2006, 08:55 AM

[No subject] - by Ron Ramirez - 01-31-2006, 08:59 AM

[No subject] - by Chuck Schwark - 01-31-2006, 09:03 AM

[No subject] - by Ron Ramirez - 01-31-2006, 12:06 PM

[No subject] - by rjm - 01-31-2006, 02:33 PM

[No subject] - by noiseguy - 02-01-2006, 10:40 PM

[No subject] - by Chuck Schwark - 02-01-2006, 10:52 PM

[No subject] - by noiseguy - 02-02-2006, 04:09 PM

[No subject] - by Chuck Schwark - 02-02-2006, 04:44 PM

[No subject] - by noiseguy - 02-17-2006, 12:09 PM

[No subject] - by rjm - 02-17-2006, 01:15 PM

[No subject] - by noiseguy - 03-26-2006, 11:45 PM

[No subject] - by rjm - 03-27-2006, 01:01 AM

[No subject] - by noiseguy - 03-27-2006, 08:12 AM

[No subject] - by noiseguy - 03-27-2006, 08:34 AM

View a Printable Version

Users browsing this thread: 3 Guest(s)

Recent Posts
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM
Philco 91 Speaker Replacement
Yes, I often have to substitute, then keep an eye out for an original. In the meantime, the radio is working and being e...RodB — 08:02 AM

Who's Online

There are currently 4963 online users. [Complete List]
» 2 Member(s) | 4961 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me