08-05-2021, 05:22 PM
A source of plastic try using a old tooth brush. Cut right at the narrow part heat with a Bic lighter insert right size allen wrench adjust OD an good to go. Good Luck David
|
Anyone have a tool for this?
« Next Oldest | Next Newest »
Messages In This Thread
Anyone have a tool for this? - by BrendaAnnD - 07-12-2021, 02:01 AM
RE: Anyone have a tool for this? - by falcon123 - 08-05-2021, 06:50 AM
RE: Anyone have a tool for this? - by Chas - 08-05-2021, 11:21 AM
RE: Anyone have a tool for this? - by David - 08-05-2021, 05:22 PM
RE: Anyone have a tool for this? - by Steve Davis - 08-05-2021, 06:02 PM
Users browsing this thread: 1 Guest(s) |
