12-22-2021, 11:33 PM
Measure the hv on pin 2 of the 26 tubes (from the chassis). Should see about 90vdc or better on all of them. Touch pin 3 of the 27. Sound hear a loud buzz. Pin 2 has hv on it. If that looks good connect your ant wire to each one of the tuning cap's stator one at a time (the part that doesn't move) and see if you can hear a station while tuning around. Or you can use your generator.
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!
Terry
