|
Philco 39-6C
05-23-2011, 06:58 PM
Changed caps. It works well, but no amplification. When volume is low, it plays fine--increase volume--distortion. Hooked up extension speaker but more of the same. Used a signal generator at grid of 42 power tube, but same low volume. I assume it is this stage. Tried changing tube. I was thinking about removing the wires of the output transformer to give it an ohm check. Any ideas?
« Next Oldest | Next Newest »
Messages In This Thread
Philco 39-6C - by radiola - 05-23-2011, 06:58 PM
Re: Philco 39-6C - by Ron Ramirez - 05-23-2011, 07:04 PM
Re: Philco 39-6C - by 7estatdef - 05-23-2011, 07:32 PM
Re: Philco 39-6C - by BILL - 05-24-2011, 02:47 PM
Re: Philco 39-6C - by radiola - 05-24-2011, 05:35 PM
Re: Philco 39-6C - by codefox1 - 05-24-2011, 06:21 PM
Re: Philco 39-6C - by radiola - 05-24-2011, 06:29 PM
Re: Philco 39-6C - by Ron Ramirez - 05-24-2011, 07:14 PM
Re: Philco 39-6C - by codefox1 - 05-24-2011, 08:14 PM
Re: Philco 39-6C - by Ed Locker - 05-25-2011, 07:59 AM
Re: Philco 39-6C - by 7estatdef - 05-25-2011, 04:55 PM
Re: Philco 39-6C - by Ron Ramirez - 05-25-2011, 06:09 PM
Re: Philco 39-6C - by radiola - 05-26-2011, 01:44 AM
Re: Philco 39-6C - by codefox1 - 05-26-2011, 12:44 PM
Users browsing this thread: 1 Guest(s) |
