Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Model 90 bezel
#9

Thanks Ron for the info! I picked up one by default at Ktown yesterday that was in the auction. I was talking w/Mike (walrus) who has a 90 and he was saying that he has never seen one with a bakelite bezel. I was a little surprised I seen both but didn't know if there was any rhyme or reason for the implementation of one vs the other. And Now I know.

I have a request for someone w/magical powers. Over in the Library could I.F. frequency for the different 90's chassis be written in on the schematic and service bulletins? It's not listed in the service literature per say and is list somewhere in the Library. It took me a little digging around to find it. Having it on the schematic would very handy for all who are servicing these sets.

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry


Messages In This Thread
Model 90 bezel - by Radioroslyn - 05-13-2023, 06:45 PM
RE: Model 90 bezel - by Ron Ramirez - 05-13-2023, 08:06 PM
RE: Model 90 bezel - by Brad Winder - 05-14-2023, 10:11 AM
RE: Model 90 bezel - by Ron Ramirez - 05-14-2023, 10:14 AM
RE: Model 90 bezel - by Brad Winder - 05-14-2023, 10:19 AM
RE: Model 90 bezel - by klondike98 - 05-14-2023, 10:49 AM
RE: Model 90 bezel - by Ron Ramirez - 05-14-2023, 11:41 AM
RE: Model 90 bezel - by Ron Ramirez - 05-14-2023, 11:53 AM
RE: Model 90 bezel - by Radioroslyn - 05-14-2023, 12:19 PM
RE: Model 90 bezel - by Ron Ramirez - 05-14-2023, 01:10 PM
RE: Model 90 bezel - by Nathan Slingerland - 05-14-2023, 09:12 PM
RE: Model 90 bezel - by Radioroslyn - 05-15-2023, 08:52 AM
RE: Model 90 bezel - by Ron Ramirez - 05-15-2023, 10:56 AM
RE: Model 90 bezel - by Radioroslyn - 05-16-2023, 09:29 AM
RE: Model 90 bezel - by Ron Ramirez - 05-16-2023, 10:14 AM
RE: Model 90 bezel - by admin - 05-16-2023, 10:16 AM
RE: Model 90 bezel - by Ron Ramirez - 05-16-2023, 12:51 PM
RE: Model 90 bezel - by DaleHCook - 05-16-2023, 05:53 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Mrfixr55, its working now. I cleaned the switches and sockets with spray cleaner. Thanks for helping on this one.daveone23 — 06:26 PM
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM

[-]
Who's Online
There are currently 5395 online users. [Complete List]
» 1 Member(s) | 5394 Guest(s)
Avatar

>