Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 38-10 faux finish?
#2

Sure looks like it. I've wiped them down w/a soft cloth and oms to clean off dirt and smoking residue. And then resprayed w/sanding sealer (a few coats). Do any t/u work and respray w/gloss. Looks like new.

GL w/your new project!

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry


Messages In This Thread
Philco 38-10 faux finish? - by Phil27 - 09-19-2023, 04:16 PM
RE: Philco 38-10 faux finish? - by Radioroslyn - 09-19-2023, 04:46 PM
RE: Philco 38-10 faux finish? - by radiorich - 09-19-2023, 05:15 PM
RE: Philco 38-10 faux finish? - by klondike98 - 09-19-2023, 06:25 PM
RE: Philco 38-10 faux finish? - by Phil27 - 09-19-2023, 06:35 PM
RE: Philco 38-10 faux finish? - by Radioroslyn - 09-19-2023, 07:23 PM
RE: Philco 38-10 faux finish? - by Arran - 09-19-2023, 09:22 PM
RE: Philco 38-10 faux finish? - by radiorich - 09-19-2023, 09:38 PM
RE: Philco 38-10 faux finish? - by Phil27 - 10-08-2023, 11:07 AM
RE: Philco 38-10 faux finish? - by Paul Philco322 - 10-08-2023, 11:44 AM
RE: Philco 38-10 faux finish? - by radiorich - 10-08-2023, 12:27 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Mrfixr55, its working now. I cleaned the switches and sockets with spray cleaner. Thanks for helping on this one.daveone23 — 06:26 PM
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM

[-]
Who's Online
There are currently no members online.

>