|
Philco Model 95
08-02-2011, 07:47 AM
Quote:Any pointers? (the cord not the bj)I had to read your post again after seeing that last sentence...  to make sure you meant ball joint. Can't help you there...I'm afraid I can't help you on the cord, either. I've been lucky enough (so far) to not have had to do this work. All I can tell you is that no springs were used, only metal cord. -- Ron Ramirez Ferdinand IN
« Next Oldest | Next Newest »
Messages In This Thread
Philco Model 95 - by 7estatdef - 08-01-2011, 07:49 PM
Re: Philco Model 95 - by Ron Ramirez - 08-02-2011, 07:47 AM
Re: Philco Model 95 - by 7estatdef - 08-02-2011, 09:27 AM
Re: Philco Model 95 - by Chuck Schwark - 08-02-2011, 10:11 AM
Re: Philco Model 95 - by Dave D - 08-02-2011, 11:03 AM
Re: Philco Model 95 - by 7estatdef - 08-02-2011, 11:21 AM
Re: Philco Model 95 - by Chuck Schwark - 08-02-2011, 01:00 PM
Re: Philco Model 95 - by 7estatdef - 08-02-2011, 02:43 PM
Re: Philco Model 95 - by Ron Ramirez - 08-02-2011, 03:05 PM
Re: Philco Model 95 - by 7estatdef - 08-02-2011, 03:33 PM
Re: Philco Model 95 - by Ron Ramirez - 08-02-2011, 04:24 PM
Re: Philco Model 95 - by Chuck Schwark - 08-02-2011, 08:20 PM
Re: Philco Model 95 - by 7estatdef - 08-03-2011, 08:56 PM
Re: Philco Model 95 - by TA Forbes - 08-03-2011, 10:17 PM
Re: Philco Model 95 - by 7estatdef - 08-04-2011, 05:51 AM
Re: Philco Model 95 - by TA Forbes - 08-04-2011, 05:05 PM
Re: Philco Model 95 - by Chuck Schwark - 08-04-2011, 08:41 PM
Users browsing this thread: 1 Guest(s) |
