|
Removing Poly finish from a Philco 46-480
01-22-2012, 12:07 PM
I tried using acetone to remove the poly finish. It was a bit gummy and if I didn't pay close attention to the timing, the finish would re-solidify in clumps and stick to the surface. After a little experimenting, I think I got a process figured out. In a month or so I am going to start working on it seriuosly. I will let you know how it goes.
« Next Oldest | Next Newest »
Messages In This Thread
Removing Poly finish from a Philco 46-480 - by Jbaker - 11-26-2011, 10:41 AM
RE: Removing Poly finish from a Philco 46-480 - by jadaman - 03-19-2012, 08:18 PM
RE: Removing Poly finish from a Philco 46-480 - by Arran - 03-20-2012, 12:36 AM
Re: Removing Poly finish from a Philco 46-480 - by Ron Ramirez - 11-26-2011, 01:45 PM
Re: Removing Poly finish from a Philco 46-480 - by codefox1 - 11-26-2011, 02:53 PM
Re: Removing Poly finish from a Philco 46-480 - by TimC - 11-26-2011, 04:25 PM
Re: Removing Poly finish from a Philco 46-480 - by Jbaker - 11-26-2011, 08:03 PM
Re: Removing Poly finish from a Philco 46-480 - by dnitram - 01-13-2012, 02:41 AM
Re: Removing Poly finish from a Philco 46-480 - by Jbaker - 01-13-2012, 07:41 PM
Re: Removing Poly finish from a Philco 46-480 - by Jbaker - 01-22-2012, 12:07 PM
Re: Removing Poly finish from a Philco 46-480 - by Arran - 01-22-2012, 11:55 PM
Re: Removing Poly finish from a Philco 46-480 - by Jbaker - 02-03-2012, 08:59 PM
Re: Removing Poly finish from a Philco 46-480 - by codefox1 - 02-11-2012, 09:03 PM
Re: Removing Poly finish from a Philco 46-480 - by Arran - 02-11-2012, 10:57 PM
Re: Removing Poly finish from a Philco 46-480 - by Jbaker - 02-15-2012, 09:32 PM
Users browsing this thread: 1 Guest(s) |
