|
Philco Model 60 coils
03-19-2012, 09:44 PM
(03-19-2012, 09:14 PM)morzh Wrote: Your resistor measures 11 Ohm because it is in parallel to the antenna coil that actually says "11 Ohm" on it. Thanks...tricky concept that could trip you up easily. I found the calculator online...of course you have to know that the resistors are in parallel.
« Next Oldest | Next Newest »
Messages In This Thread
Philco Model 60 coils - by sjhs1962 - 02-27-2012, 08:51 PM
RE: Philco Model 60 coils - by 7estatdef - 02-27-2012, 08:56 PM
RE: Philco Model 60 coils - by sjhs1962 - 02-27-2012, 09:29 PM
RE: Philco Model 60 coils - by 7estatdef - 02-27-2012, 10:10 PM
RE: Philco Model 60 coils - by sjhs1962 - 03-19-2012, 08:39 AM
RE: Philco Model 60 coils - by codefox1 - 03-19-2012, 01:59 PM
RE: Philco Model 60 coils - by 7estatdef - 03-19-2012, 04:33 PM
RE: Philco Model 60 coils - by sjhs1962 - 03-19-2012, 08:51 PM
RE: Philco Model 60 coils - by morzh - 03-19-2012, 09:14 PM
RE: Philco Model 60 coils - by sjhs1962 - 03-19-2012, 09:44 PM
RE: Philco Model 60 coils - by Chuck Schwark - 03-20-2012, 08:27 AM
RE: Philco Model 60 coils - by 7estatdef - 03-21-2012, 06:18 PM
RE: Philco Model 60 coils - by Ron Ramirez - 03-21-2012, 06:38 PM
RE: Philco Model 60 coils - by 37fordcab - 05-10-2012, 11:01 AM
RE: Philco Model 60 coils - by sjhs1962 - 03-22-2012, 08:02 PM
RE: Philco Model 60 coils - by sjhs1962 - 04-02-2012, 01:39 PM
RE: Philco Model 60 coils - by Chuck Schwark - 04-02-2012, 01:47 PM
RE: Philco Model 60 coils - by CrumblingWires - 04-05-2012, 06:22 PM
RE: Philco Model 60 coils - by Bob Andersen - 04-05-2012, 10:18 PM
RE: Philco Model 60 coils - by sjhs1962 - 04-11-2012, 09:42 PM
RE: Philco Model 60 coils - by Bob Andersen - 04-12-2012, 10:08 AM
RE: Philco Model 60 coils - by sjhs1962 - 04-12-2012, 02:44 PM
RE: Philco Model 60 coils - by Bob Andersen - 04-12-2012, 02:59 PM
RE: Philco Model 60 coils - by sjhs1962 - 04-18-2012, 01:15 PM
RE: Philco Model 60 coils - by 7estatdef - 04-18-2012, 04:41 PM
RE: Philco Model 60 coils - by 7estatdef - 05-10-2012, 06:59 PM
Users browsing this thread: 1 Guest(s) |
