Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5

New Project16B Cathedral
#5

You can use 10 MF for both. Get 450 VDC types and observe polarity. I would try to combine everything in one order, all the paper caps (just use 630 volt types everywheew and definiitly I would add a set of carbon resistors, really costs so little and makes a big difference when you get done and fire it up.


Messages In This Thread
New Project16B Cathedral - by LedHed - 04-26-2012, 08:53 AM
RE: New Project16B Cathedral - by TA Forbes - 04-26-2012, 11:53 AM
RE: New Project16B Cathedral - by Chuck Schwark - 04-26-2012, 12:34 PM
RE: New Project16B Cathedral - by LedHed - 04-26-2012, 02:09 PM
RE: New Project16B Cathedral - by codefox1 - 04-26-2012, 03:18 PM
RE: New Project16B Cathedral - by TA Forbes - 04-26-2012, 06:09 PM
RE: New Project16B Cathedral - by Glenn Roberts - 04-27-2012, 03:13 AM
RE: New Project16B Cathedral - by Chuck Schwark - 04-27-2012, 09:03 AM
RE: New Project16B Cathedral - by Art Hoch - 05-31-2012, 07:47 PM
RE: New Project16B Cathedral - by TA Forbes - 05-31-2012, 10:41 PM
RE: New Project16B Cathedral - by jerryhawthorne - 06-03-2012, 09:44 PM
RE: New Project16B Cathedral - by codefox1 - 06-04-2012, 12:44 PM
RE: New Project16B Cathedral - by gary rabbitt - 06-04-2012, 11:38 PM
RE: New Project16B Cathedral - by jerryhawthorne - 06-21-2012, 01:33 AM
RE: New Project16B Cathedral - by AI2V - 06-21-2012, 08:32 AM
RE: New Project16B Cathedral - by TA Forbes - 06-21-2012, 11:36 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Mrfixr55, its working now. I cleaned the switches and sockets with spray cleaner. Thanks for helping on this one.daveone23 — 06:26 PM
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM

[-]
Who's Online
There are currently 3905 online users. [Complete List]
» 1 Member(s) | 3904 Guest(s)
Avatar

>