Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

37-660 Alignment Issue
#3

If I had to guess (and I do) Icon_wtf you are on the wrong peak. ie if the LO is to be at 6.53MHz when you tune 7Mhz, you have it peaked at 7.47 Mhz on the LO

turn the signal generator level down, and try to find a peak at 7MHz with the trimmer turned in tighter.

I would also assume the 1150 pF cap would be paper, you could try putting 2 .0022uF caps in series (1100pF) and see if the situation improves.

John
Las Vegas, NV USA


Messages In This Thread
37-660 Alignment Issue - by marv - 04-26-2012, 07:10 PM
RE: 37-660 Alignment Issue - by TA Forbes - 04-26-2012, 08:09 PM
RE: 37-660 Alignment Issue - by LASJayhawk - 04-27-2012, 12:04 AM
RE: 37-660 Alignment Issue - by marv - 05-09-2012, 02:37 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Mrfixr55, its working now. I cleaned the switches and sockets with spray cleaner. Thanks for helping on this one.daveone23 — 06:26 PM
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM

[-]
Who's Online
There are currently no members online.

>