Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 118H Cabinet, Question for Ron
#3

(04-26-2012, 10:52 AM)Ron Ramirez Wrote:  At work so will have to answer the wood type later...

"a few pieces that can off the legs"? I think you mean came off the legs?

As I recall from the one I had previously (which glennpr now owns) along with one or two others I have seen, I think Perfect Brown would be good for the cabinet overall - something a bit darker than Medium Walnut, but not a lot darker; and it needs to be an "Ultra Classic" product so you don't lose the woodgrain. The front panel originally had a "sunburst" look with the majority being Medium Walnut, with Perfect Brown around the edges. Just take a look at any of the radios being sold by Arran's favorite eBay seller "Foggy", and you will see what I mean - only this effect is on the front panel alone, not on the edges of the cabinet.

I attached these again. If you need any additional pictures just let me know.
Glenn
http://s1230.photobucket.com/albums/ee48...18left.jpg
http://s1230.photobucket.com/albums/ee48...18full.jpg
http://s1230.photobucket.com/albums/ee48...8front.jpg

Happily back in Illinois..not.


Messages In This Thread
RE: Philco 118H Cabinet, Question for Ron - by Glenn Roberts - 04-27-2012, 03:11 AM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Mrfixr55, its working now. I cleaned the switches and sockets with spray cleaner. Thanks for helping on this one.daveone23 — 06:26 PM
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM

[-]
Who's Online
There are currently 3994 online users. [Complete List]
» 1 Member(s) | 3993 Guest(s)
Avatar

>