08-17-2012, 10:30 PM
Sure.
Did you see the pictures of the finished cabinet?
http://www.philcoradio.com/phorum/showth...031&page=2
By the way, I used a couple of rubber spacers only on the front of mine. They were about 1/4 inch thick, BUT, I do not think that there were spacers in there from the factory. Simply, the board supporting the front of the chassis sagged a bit. If yours has the knobs with the thick shaft (the area that penetrates the cabinet) you may want to switch to the earlier version with the thin shaft. They look the same and centering the chassis using them is not nearly so critical. They came on the 1929s. Lots of them around. Just don’t tell Ron that you are using the wrong knobs.
Did you see the pictures of the finished cabinet?
http://www.philcoradio.com/phorum/showth...031&page=2
By the way, I used a couple of rubber spacers only on the front of mine. They were about 1/4 inch thick, BUT, I do not think that there were spacers in there from the factory. Simply, the board supporting the front of the chassis sagged a bit. If yours has the knobs with the thick shaft (the area that penetrates the cabinet) you may want to switch to the earlier version with the thin shaft. They look the same and centering the chassis using them is not nearly so critical. They came on the 1929s. Lots of them around. Just don’t tell Ron that you are using the wrong knobs.
