|
philco model 16
05-16-2007, 10:55 AM
i did lite it up again at 90 volts, i think now all the filaments lite , it seemed to to run safe on one of the electrolitics i changed one of the ones to 10 mfd to a new one ( 91 ) the other 98 still one from later re repair ( repair shop i guess ) plate voltages measured on 2 of them were low 2 and 7 volts .
« Next Oldest | Next Newest »
Messages In This Thread
philco model 16 - by ckc - 04-29-2007, 07:13 AM
[No subject] - by Chuck Schwark - 04-29-2007, 10:26 AM
[No subject] - by ckc - 04-29-2007, 12:03 PM
[No subject] - by Chuck Schwark - 04-29-2007, 01:47 PM
[No subject] - by ckc - 04-29-2007, 03:27 PM
[No subject] - by ckc - 04-29-2007, 04:14 PM
[No subject] - by Sean - 04-30-2007, 07:09 AM
[No subject] - by Sean - 04-30-2007, 08:14 PM
[No subject] - by ckc - 05-02-2007, 06:34 PM
[No subject] - by Sean - 05-03-2007, 07:21 AM
[No subject] - by ckc - 05-03-2007, 02:49 PM
[No subject] - by Sean - 05-03-2007, 04:10 PM
[No subject] - by ckc - 05-03-2007, 05:45 PM
[No subject] - by Sean - 05-04-2007, 07:43 AM
[No subject] - by ckc - 05-09-2007, 04:08 PM
[No subject] - by Sean - 05-09-2007, 04:14 PM
[No subject] - by ckc - 05-09-2007, 04:42 PM
[No subject] - by Sean - 05-10-2007, 07:09 AM
[No subject] - by ckc - 05-11-2007, 09:32 PM
[No subject] - by Sean - 05-12-2007, 07:16 PM
[No subject] - by ckc - 05-16-2007, 10:55 AM
[No subject] - by ckc - 05-18-2007, 04:20 PM
[No subject] - by ckc - 05-18-2007, 04:41 PM
[No subject] - by Sean - 05-19-2007, 07:26 PM
[No subject] - by ckc - 05-28-2007, 01:52 PM
[No subject] - by Sean - 05-28-2007, 04:37 PM
[No subject] - by ckc - 06-01-2007, 10:40 PM
Users browsing this thread: 1 Guest(s) |
