Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Another Volume Control Question
#1

I have yet another radio [42-PT95] which has excellent sound and is working perfectly, except for one thing. The lowest volume when the radio turns on is higher than I would like.

There is no crackling or static when the volume is increased (and it does steadily increase), but it is a mid level volume when set in the low position.

Is this a dirty contact problem in the volume control.

If so how, do I successfully clean this.

- Do I need to remove from radio first ?
- Do I need to take apart ?
- What should I use to clean it ? [be specific please with Name of product and possible link to product]
- Do I need to replace the volume control ?

Sorry for the questions about minute details, but I have messed up a few radios by using the incorrect proceedure or wrong type of cleaner etc. I would like to avoid that this time if possible.

Thanks.


Messages In This Thread
Another Volume Control Question - by winkydink - 11-20-2012, 10:23 AM
RE: Another Volume Control Question - by codefox1 - 11-20-2012, 11:20 AM
RE: Another Volume Control Question - by codefox1 - 11-21-2012, 11:08 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Mrfixr55, its working now. I cleaned the switches and sockets with spray cleaner. Thanks for helping on this one.daveone23 — 06:26 PM
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM

[-]
Who's Online
There are currently 4021 online users. [Complete List]
» 1 Member(s) | 4020 Guest(s)
Avatar

>