03-24-2013, 02:00 PM
Having made a 115vdc power supply and received all the caps to the specs. I have one question. #14 tubes are not on any tube tester that I can find. They are like a #24a. The filaments to the #14 is 13.5 vdc. Has anyone have this #14 on there tester? If you do could you tell the tester and the settings. Also the#24A setting on the same tester. I just would like to be sure they are good.
Forgot about the two resistors. I have never seen these before for the wattage is what I'm worried about.
http://www.philcorepairbench.com/flexrest.htm
Model 46 is not shown to have them. Nor does it say there wattage.
Is it best to replace them? Like the old dog bones?
Forgot about the two resistors. I have never seen these before for the wattage is what I'm worried about.
http://www.philcorepairbench.com/flexrest.htm
Model 46 is not shown to have them. Nor does it say there wattage.
Is it best to replace them? Like the old dog bones?
