|
48-1262 low voltage
04-04-2013, 07:48 AM
Looks like you're only getting half of your voltage doubler. Recheck your connections in the power supply... voltage doublers can be tricky if you're not used to them. Pay special attention to C101 and 102, which, along with the 50X6 form the doubler circuit. Check the polarity of the caps, then check it again. Note the negative end of C101 connects to the positive end of C102.
« Next Oldest | Next Newest »
Messages In This Thread
48-1262 low voltage - by ke5yum - 04-04-2013, 07:14 AM
RE: 48-1262 low voltage - by BrendaAnnD - 04-04-2013, 07:48 AM
RE: 48-1262 low voltage - by ke5yum - 04-04-2013, 08:27 AM
RE: 48-1262 low voltage - by morzh - 04-04-2013, 10:41 AM
RE: 48-1262 low voltage - by ke5yum - 04-05-2013, 06:59 AM
RE: 48-1262 low voltage - by ke5yum - 04-05-2013, 08:04 AM
RE: 48-1262 low voltage - by BrendaAnnD - 04-05-2013, 09:40 AM
RE: 48-1262 low voltage - by ke5yum - 04-05-2013, 10:19 AM
RE: 48-1262 low voltage - by ke5yum - 04-05-2013, 12:30 PM
Users browsing this thread: 1 Guest(s) |
