Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Repurpose a Philco
#3

No, no,no,Icon_thumbdownIcon_thumbdownIcon_thumbdownIcon_cryIcon_cry

Joe Bratcher near Louisville, KY


Messages In This Thread
Repurpose a Philco - by mis4tun81 - 04-09-2013, 11:31 AM
RE: Repurpose a Philco - by jerryhawthorne - 04-09-2013, 04:55 PM
RE: Repurpose a Philco - by w4rtc - 04-09-2013, 05:10 PM
RE: Repurpose a Philco - by Doug Houston - 04-09-2013, 06:24 PM
RE: Repurpose a Philco - by Arran - 04-09-2013, 06:31 PM
RE: Repurpose a Philco - by shaler78 - 04-09-2013, 07:39 PM
RE: Repurpose a Philco - by shaler78 - 04-09-2013, 08:09 PM
RE: Repurpose a Philco - by chris25260880 - 04-09-2013, 11:40 PM
RE: Repurpose a Philco - by codefox1 - 04-10-2013, 09:27 AM
RE: Repurpose a Philco - by PhilcoMike - 04-10-2013, 10:23 AM
RE: Repurpose a Philco - by mis4tun81 - 04-10-2013, 10:40 AM
RE: Repurpose a Philco - by Art Hoch - 04-10-2013, 11:09 AM
RE: Repurpose a Philco - by mis4tun81 - 04-10-2013, 11:19 AM
RE: Repurpose a Philco - by mis4tun81 - 04-10-2013, 11:21 AM
RE: Repurpose a Philco - by mis4tun81 - 04-10-2013, 11:26 AM
RE: Repurpose a Philco - by Ron Ramirez - 04-10-2013, 12:38 PM
RE: Repurpose a Philco - by mis4tun81 - 04-10-2013, 02:55 PM
RE: Repurpose a Philco - by Gene Pederson - 04-10-2013, 03:15 PM
RE: Repurpose a Philco - by shaler78 - 04-10-2013, 03:41 PM
RE: Repurpose a Philco - by Phlogiston - 04-10-2013, 06:49 PM
RE: Repurpose a Philco - by TimC - 04-10-2013, 08:10 PM
RE: Repurpose a Philco - by Arran - 04-10-2013, 08:38 PM
RE: Repurpose a Philco - by GarySP - 04-10-2013, 09:03 PM
RE: Repurpose a Philco - by Arran - 04-10-2013, 09:59 PM
RE: Repurpose a Philco - by gary rabbitt - 04-11-2013, 02:56 PM
RE: Repurpose a Philco - by DeckApe - 04-13-2013, 09:55 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Mrfixr55, its working now. I cleaned the switches and sockets with spray cleaner. Thanks for helping on this one.daveone23 — 06:26 PM
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM

[-]
Who's Online
There are currently 4049 online users. [Complete List]
» 1 Member(s) | 4048 Guest(s)
Avatar

>