Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Replaced the capacitors but all I get is a hum
#17

Thanks Jerry. I will keep that in mind when I check them out today. I only see the value of the resistors listed in ohms in my schematics. Isn't wattage important too? From what I have been reading you don't want to go low on your wattage or you risk overheating. Is there a way to see what the original wattage of these are providing I have to replace any of them?

Andrew


Messages In This Thread
RE: Replaced the capacitors but all I get is a hum - by Andrew Fleck - 11-03-2013, 09:27 AM



Users browsing this thread: 3 Guest(s)