Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Missed out on a nice predicta by 4 hours
#5

I see that as well, there is a goof in my region trying to get $2900 out of a barber pole Predicta and you can clearly see that it has NOT been electrically restored, as is it's probably worth maybe $400 on a good day. He also has a Princess chalk full of his trademark hack repairs, he wants $1500 for that, probably not worth $250 as it sits, it may have been had he not messed with it. The Holiday and Princess models are the most common by far, but the Holiday sets have that crappy 110 degree short neck CRT with the 2.3 volt heater, many of the ones with good tubes have either replacements or rebuilds in them.
They are not exactly rare sets, sometimes the thing to do is just contact one of these guys, give it a look, and make an offer. Even as working about the only thing they have going for them is the unique design, they were never great sets as new.
Regards
Arran


Messages In This Thread
RE: Missed out on a nice predicta by 4 hours - by Arran - 12-23-2013, 01:00 AM



Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM
Philco 91 Speaker Replacement
Yes, I often have to substitute, then keep an eye out for an original. In the meantime, the radio is working and being e...RodB — 08:02 AM

[-]
Who's Online
There are currently no members online.

>