Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Any idea on this model?
#6

Don't take my word for it then, what do I know. Icon_rolleyes

If you prefer, you can tell your friends that you have the only custom-built Philco Transitone in existence, built especially for James Carmine.

But it would not be true - it's still an orphan chassis in a non-original cabinet.

--
Ron Ramirez
Ferdinand IN


Messages In This Thread
Any idea on this model? - by WyTex - 01-10-2014, 08:33 AM
RE: Any idea on this model? - by Ron Ramirez - 01-10-2014, 11:45 AM
RE: Any idea on this model? - by WyTex - 01-10-2014, 03:23 PM
RE: Any idea on this model? - by klondike98 - 01-10-2014, 03:34 PM
RE: Any idea on this model? - by WyTex - 01-10-2014, 03:48 PM
RE: Any idea on this model? - by Ron Ramirez - 01-10-2014, 03:49 PM
RE: Any idea on this model? - by morzh - 01-10-2014, 04:28 PM
RE: Any idea on this model? - by WyTex - 01-10-2014, 04:31 PM
RE: Any idea on this model? - by Ron Ramirez - 01-10-2014, 04:39 PM
RE: Any idea on this model? - by WyTex - 01-10-2014, 05:41 PM
RE: Any idea on this model? - by Eric T - 01-10-2014, 09:54 PM
RE: Any idea on this model? - by hsusmann - 01-10-2014, 10:30 PM
RE: Any idea on this model? - by jontz - 01-10-2014, 10:34 PM
RE: Any idea on this model? - by hsusmann - 01-10-2014, 10:41 PM
RE: Any idea on this model? - by JimZ - 01-11-2014, 09:18 AM
RE: Any idea on this model? - by Jamie - 01-11-2014, 09:45 AM
RE: Any idea on this model? - by Ron Ramirez - 01-11-2014, 02:19 PM
RE: Any idea on this model? - by klondike98 - 01-11-2014, 02:28 PM
RE: Any idea on this model? - by Joe Rossi - 01-11-2014, 04:27 PM
RE: Any idea on this model? - by WyTex - 01-11-2014, 09:19 PM
RE: Any idea on this model? - by Ron Ramirez - 01-11-2014, 09:44 PM
RE: Any idea on this model? - by Arran - 01-12-2014, 01:20 AM
RE: Any idea on this model? - by Joeztech - 01-12-2014, 11:20 AM
RE: Any idea on this model? - by Paul Philco322 - 01-12-2014, 02:21 PM
RE: Any idea on this model? - by LASJayhawk - 01-12-2014, 08:01 PM



Users browsing this thread: 1 Guest(s)