Thread Rating:
  • 1 Vote(s) - 1 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Not receiving all stations on AM
#27

Well, My other radios do not have a hum in them. I get this hum whether I am tuning in a station or not, on a real strong stations it doesn't seem to be as bad.... it also seems to be only on AM not FM. Don't know if this has anything to do with it or not but I don't seem to be able to pull in any stations on SW either. I was hoping to get some ideas about where to look, what might cause it, etc. I guess right now I will check any resistors I did not replace, I actually replaced most of them but there are a few that seemed good that I did not replace, I will check them again. I spose I should check the SW coil again also in case I missed it to make sure it isnt why I dont get anything there. Thanks again for all the help I have received, and im sure will receive in the future.


Messages In This Thread
Not receiving all stations on AM - by Warren - 02-25-2014, 01:38 PM
RE: Not recieving all stations on AM - by Warren - 02-25-2014, 08:40 PM
RE: Not receiving all stations on AM - by Warren - 02-25-2014, 11:28 PM
RE: Not receiving all stations on AM - by Jamie - 02-26-2014, 07:59 AM
RE: Not receiving all stations on AM - by Mondial - 02-26-2014, 10:36 AM
RE: Not receiving all stations on AM - by Warren - 02-26-2014, 02:00 PM
RE: Not receiving all stations on AM - by Jamie - 02-26-2014, 10:28 PM
RE: Not receiving all stations on AM - by Warren - 02-26-2014, 11:58 PM
RE: Not receiving all stations on AM - by Mondial - 02-27-2014, 10:07 AM
RE: Not receiving all stations on AM - by Warren - 02-27-2014, 05:21 PM
RE: Not receiving all stations on AM - by exray - 02-27-2014, 05:36 PM
RE: Not receiving all stations on AM - by Warren - 02-27-2014, 10:05 PM
RE: Not receiving all stations on AM - by morzh - 02-27-2014, 10:17 PM
RE: Not receiving all stations on AM - by Warren - 02-27-2014, 11:26 PM
RE: Not receiving all stations on AM - by Mondial - 02-28-2014, 10:38 AM
RE: Not receiving all stations on AM - by morzh - 02-28-2014, 10:53 AM
RE: Not receiving all stations on AM - by Warren - 02-28-2014, 02:03 PM
RE: Not receiving all stations on AM - by morzh - 02-28-2014, 02:43 PM
RE: Not receiving all stations on AM - by Warren - 03-01-2014, 07:55 PM
RE: Not receiving all stations on AM - by Warren - 03-02-2014, 11:26 PM
RE: Not receiving all stations on AM - by morzh - 03-03-2014, 08:41 AM
RE: Not receiving all stations on AM - by Warren - 03-03-2014, 01:50 PM
RE: Not receiving all stations on AM - by morzh - 03-03-2014, 02:35 PM
RE: Not receiving all stations on AM - by Warren - 03-03-2014, 03:15 PM
RE: Not receiving all stations on AM - by morzh - 03-03-2014, 03:41 PM
RE: Not receiving all stations on AM - by Warren - 03-04-2014, 02:18 PM
RE: Not receiving all stations on AM - by Warren - 03-08-2014, 11:31 PM
RE: Not receiving all stations on AM - by Warren - 03-29-2014, 10:53 PM
RE: Not receiving all stations on AM - by Warren - 03-31-2014, 12:39 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Mrfixr55, its working now. I cleaned the switches and sockets with spray cleaner. Thanks for helping on this one.daveone23 — 06:26 PM
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM

[-]
Who's Online
There are currently 3992 online users. [Complete List]
» 1 Member(s) | 3991 Guest(s)
Avatar

>