Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco D-10 needle source
#22

Sounds fine . do you have paypal?


Messages In This Thread
Philco D-10 needle source - by brownie45 - 05-28-2014, 07:37 AM
RE: Philco D-10 needle source - by TA Forbes - 05-28-2014, 09:50 AM
RE: Philco D-10 needle source - by brownie45 - 05-28-2014, 11:48 AM
RE: Philco D-10 needle source - by sam - 05-28-2014, 12:18 PM
RE: Philco D-10 needle source - by Warren - 05-28-2014, 12:56 PM
RE: Philco D-10 needle source - by TA Forbes - 05-28-2014, 10:17 PM
RE: Philco D-10 needle source - by Ron Ramirez - 05-29-2014, 04:42 AM
RE: Philco D-10 needle source - by brownie45 - 05-29-2014, 05:58 AM
RE: Philco D-10 needle source - by Randy H. - 06-09-2014, 06:11 PM
RE: Philco D-10 needle source - by Ron Ramirez - 06-09-2014, 07:18 PM
RE: Philco D-10 needle source - by brownie45 - 06-09-2014, 08:39 PM
RE: Philco D-10 needle source - by Randy H. - 06-13-2014, 04:46 PM
RE: Philco D-10 needle source - by Ron Ramirez - 06-13-2014, 05:00 PM
RE: Philco D-10 needle source - by Skip - 06-13-2014, 05:11 PM
RE: Philco D-10 needle source - by Warren - 06-13-2014, 09:22 PM
RE: Philco D-10 needle source - by w4rtc - 06-14-2014, 06:53 AM
RE: Philco D-10 needle source - by brownie45 - 06-15-2014, 11:24 AM
RE: Philco D-10 needle source - by w4rtc - 06-15-2014, 04:01 PM
RE: Philco D-10 needle source - by brownie45 - 06-15-2014, 06:02 PM
RE: Philco D-10 needle source - by Warren - 06-15-2014, 07:29 PM
RE: Philco D-10 needle source - by w4rtc - 06-15-2014, 10:22 PM
RE: Philco D-10 needle source - by Warren - 06-16-2014, 12:53 AM
RE: Philco D-10 needle source - by w4rtc - 06-16-2014, 09:35 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Mrfixr55, its working now. I cleaned the switches and sockets with spray cleaner. Thanks for helping on this one.daveone23 — 06:26 PM
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM

[-]
Who's Online
There are currently no members online.

>