|
Volume getting lower?
07-26-2014, 07:08 PM
7/26/14 - Both Jerry and Morzh - you guys got it !! I was a tube. After taking a few minutes and swapping out some of the tubes with other known good ones, it turns out it was the 50Y7GT tube. When I rechecked the tube in the tube tester it tested BAD on a second setting (I guess a second filament) that I had overlooked to check. When I popped in the extra one I had - it went back to full volume. Thanks guys !
« Next Oldest | Next Newest »
Messages In This Thread
Volume getting lower? - by ODPILOT - 07-25-2014, 10:23 PM
RE: Volume getting lower? - by morzh - 07-25-2014, 10:38 PM
RE: Volume getting lower? - by ODPILOT - 07-26-2014, 11:59 AM
RE: Volume getting lower? - by morzh - 07-26-2014, 12:54 PM
RE: Volume getting lower? - by jerryhawthorne - 07-26-2014, 04:27 PM
RE: Volume getting lower? - by codefox1 - 07-26-2014, 04:34 PM
RE: Volume getting lower? - by ODPILOT - 07-26-2014, 07:08 PM
RE: Volume getting lower? - by jerryhawthorne - 07-26-2014, 07:12 PM
RE: Volume getting lower? - by Arran - 07-27-2014, 07:48 AM
RE: Volume getting lower? - by ODPILOT - 07-27-2014, 09:02 AM
RE: Volume getting lower? - by Arran - 07-27-2014, 11:02 AM
RE: Volume getting lower? - by ODPILOT - 07-29-2014, 12:10 PM
Users browsing this thread: 1 Guest(s) |
