Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 38-7CS
#13

It's fine and does not vary. Now keep in mind that even when the radio is first turned on the volume is quite low and then drops even further. I replaced the candohm resistor and there's no improvement at all. I also swapped out the 6K5 with a 6Q7 after making sure nothing was connected to the diode pins - no change.


Messages In This Thread
Philco 38-7CS - by Bob Andersen - 07-24-2014, 06:32 PM
RE: Philco 38-7CS - by Bob Andersen - 07-24-2014, 06:41 PM
RE: Philco 38-7CS - by Bob Andersen - 07-24-2014, 06:48 PM
RE: Philco 38-7CS - by Bob Andersen - 07-24-2014, 06:57 PM
RE: Philco 38-7CS - by Arran - 07-24-2014, 08:34 PM
RE: Philco 38-7CS - by Bob Andersen - 07-24-2014, 08:50 PM
RE: Philco 38-7CS - by codefox1 - 07-25-2014, 12:34 PM
RE: Philco 38-7CS - by Chuck Schwark - 07-25-2014, 12:46 PM
RE: Philco 38-7CS - by morzh - 07-25-2014, 12:47 PM
RE: Philco 38-7CS - by Bob Andersen - 07-25-2014, 03:24 PM
RE: Philco 38-7CS - by morzh - 07-25-2014, 04:02 PM
RE: Philco 38-7CS - by Arran - 07-25-2014, 11:06 PM
RE: Philco 38-7CS - by Bob Andersen - 07-27-2014, 02:35 PM
RE: Philco 38-7CS - by gregb - 07-27-2014, 10:13 PM
RE: Philco 38-7CS - by Bob Andersen - 07-27-2014, 10:28 PM
RE: Philco 38-7CS - by Bob Andersen - 07-28-2014, 03:16 PM
RE: Philco 38-7CS - by Mondial - 07-28-2014, 03:26 PM
RE: Philco 38-7CS - by Bob Andersen - 07-28-2014, 04:18 PM
RE: Philco 38-7CS - by Mondial - 07-28-2014, 04:36 PM
RE: Philco 38-7CS - by Bob Andersen - 07-28-2014, 05:51 PM
RE: Philco 38-7CS - by Bob Andersen - 07-28-2014, 09:29 PM
RE: Philco 38-7CS - by Chuck Schwark - 07-29-2014, 09:35 AM
RE: Philco 38-7CS - by morzh - 07-29-2014, 09:37 AM
RE: Philco 38-7CS - by Chuck Schwark - 07-29-2014, 09:42 AM
RE: Philco 38-7CS - by morzh - 07-29-2014, 10:02 AM
RE: Philco 38-7CS - by Warren - 07-29-2014, 12:59 PM
RE: Philco 38-7CS - by gregb - 07-29-2014, 02:16 PM
RE: Philco 38-7CS - by Bob Andersen - 07-29-2014, 02:31 PM
RE: Philco 38-7CS - by Bob Andersen - 08-03-2014, 01:06 PM
RE: Philco 38-7CS - by codefox1 - 08-03-2014, 03:29 PM



Users browsing this thread: 1 Guest(s)