|
Not a good sound...
09-09-2014, 11:38 AM
Quote:The base is loose, as is the top contact so I dont know...You can re-glue the base as well as the top cap with a drop or two of glue. Then you can heat up each tube pin and flow in some fresh solder. That would eliminate a flaky connection at one of the tube pins. Also try lightly tapping the tube when testing, especially when testing for shorts. John KK4ZLF Lexington, KY "illegitimis non carborundum"
« Next Oldest | Next Newest »
Messages In This Thread
Not a good sound... - by OldRestorer - 09-08-2014, 07:16 PM
RE: Not a good sound... - by Mondial - 09-08-2014, 07:37 PM
RE: Not a good sound... - by morzh - 09-08-2014, 07:39 PM
RE: Not a good sound... - by exray - 09-08-2014, 07:40 PM
RE: Not a good sound... - by OldRestorer - 09-09-2014, 06:28 AM
RE: Not a good sound... - by Eliot Ness - 09-09-2014, 06:55 AM
RE: Not a good sound... - by OldRestorer - 09-09-2014, 07:24 AM
RE: Not a good sound... - by morzh - 09-09-2014, 08:00 AM
RE: Not a good sound... - by OldRestorer - 09-09-2014, 09:42 AM
RE: Not a good sound... - by codefox1 - 09-09-2014, 10:05 AM
RE: Not a good sound... - by OldRestorer - 09-09-2014, 11:16 AM
RE: Not a good sound... - by Eliot Ness - 09-09-2014, 11:38 AM
RE: Not a good sound... - by Phlogiston - 09-10-2014, 10:08 AM
RE: Not a good sound... - by morzh - 09-10-2014, 02:14 PM
RE: Not a good sound... - by OldRestorer - 09-10-2014, 04:16 PM
RE: Not a good sound... - by Phlogiston - 09-10-2014, 10:36 PM
RE: Not a good sound... - by OldRestorer - 09-11-2014, 12:47 PM
RE: Not a good sound... - by morzh - 09-11-2014, 02:01 PM
RE: Not a good sound... - by Phlogiston - 09-11-2014, 10:30 PM
Users browsing this thread: 1 Guest(s) |
