Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

40-165 Alignment adapter
#6

Well I hooked up one of my AC voltmeters between pins 2 and 3 of the 41 tube and I do get a deflection that gets bigger as the tone get louder. I could easily solder a couple of leads between these two pins to run to my AC voltmeter and then I could do the alignment in the cabinet. Any reason not to do it this way?
Thanks,
Keith


Messages In This Thread
40-165 Alignment adapter - by keith49vj3 - 12-31-2014, 11:47 AM
RE: 40-165 Alignment adapter - by klondike98 - 12-31-2014, 02:18 PM
RE: 40-165 Alignment adapter - by Nick3092 - 12-31-2014, 02:23 PM
RE: 40-165 Alignment adapter - by keith49vj3 - 12-31-2014, 04:11 PM
RE: 40-165 Alignment adapter - by klondike98 - 12-31-2014, 04:26 PM
RE: 40-165 Alignment adapter - by keith49vj3 - 12-31-2014, 05:12 PM
RE: 40-165 Alignment adapter - by klondike98 - 12-31-2014, 07:32 PM
RE: 40-165 Alignment adapter - by keith49vj3 - 01-01-2015, 07:20 AM
RE: 40-165 Alignment adapter - by codefox1 - 01-01-2015, 10:58 AM
RE: 40-165 Alignment adapter - by keith49vj3 - 01-01-2015, 12:04 PM
RE: 40-165 Alignment adapter - by keith49vj3 - 01-01-2015, 02:34 PM
RE: 40-165 Alignment adapter - by klondike98 - 01-01-2015, 02:44 PM
RE: 40-165 Alignment adapter - by Ron Ramirez - 01-01-2015, 04:03 PM
RE: 40-165 Alignment adapter - by keith49vj3 - 01-04-2015, 04:02 PM
RE: 40-165 Alignment adapter - by codefox1 - 01-04-2015, 04:11 PM
RE: 40-165 Alignment adapter - by klondike98 - 01-04-2015, 04:25 PM



Users browsing this thread: 1 Guest(s)