|
Differences between 46-200 and 48-200
01-04-2009, 06:41 PM
Jim Berg Wrote:I did not look up a picture of the set you are talking about, but if the back was held on by the T clips I have some round head metal trim mounts I could throw in an envelope and send you. These fit good on a few sets I tried them on.Thank you for offering to send me the trim mounts. I'll PM you my address. Brian
« Next Oldest | Next Newest »
Messages In This Thread
Differences between 46-200 and 48-200 - by scooby214 - 01-01-2009, 03:12 PM
Re: Differences between 46-200 and 48-200 - by Ron Ramirez - 01-01-2009, 11:47 PM
Re: Differences between 46-200 and 48-200 - by scooby214 - 01-02-2009, 08:58 AM
Re: Differences between 46-200 and 48-200 - by Ron Ramirez - 01-02-2009, 10:36 AM
Re: Differences between 46-200 and 48-200 - by scooby214 - 01-02-2009, 10:51 AM
Re: Differences between 46-200 and 48-200 - by Ron Ramirez - 01-02-2009, 11:23 AM
Re: Differences between 46-200 and 48-200 - by scooby214 - 01-02-2009, 11:35 AM
Re: Differences between 46-200 and 48-200 - by Doug Houston - 01-02-2009, 03:32 PM
Re: Differences between 46-200 and 48-200 - by 49Stude63 - 01-02-2009, 09:17 PM
Re: Differences between 46-200 and 48-200 - by scooby214 - 01-02-2009, 10:01 PM
Re: Differences between 46-200 and 48-200 - by Ron Ramirez - 01-02-2009, 10:57 PM
Re: Differences between 46-200 and 48-200 - by scooby214 - 01-03-2009, 12:02 AM
Re: Differences between 46-200 and 48-200 - by BDM - 01-03-2009, 04:32 AM
Re: Differences between 46-200 and 48-200 - by scooby214 - 01-03-2009, 09:46 AM
Re: Differences between 46-200 and 48-200 - by 49Stude63 - 01-03-2009, 10:49 AM
Re: Differences between 46-200 and 48-200 - by Jim Berg - 01-03-2009, 11:39 PM
Re: Differences between 46-200 and 48-200 - by scooby214 - 01-04-2009, 06:41 PM
Re: Differences between 46-200 and 48-200 - by Jim Berg - 01-04-2009, 11:38 PM
Re: Differences between 46-200 and 48-200 - by Arran - 01-05-2009, 09:28 PM
Re: Differences between 46-200 and 48-200 - by scooby214 - 01-10-2009, 06:45 PM
Users browsing this thread: 1 Guest(s) |
