|
Vernier shaft repair
01-19-2009, 08:48 PM
Has anyone re-attached the little ball bearing to the end of the vernier shaft from a 38-116 dial? Mine was broken during shipment. Perhaps it was welded or soldered but I can't tell. Thought a repair attempt is in order in case I can't locate a replacement. Any ideas on how to do this will be greatly appreciated.
Curt
« Next Oldest | Next Newest »
Messages In This Thread
Vernier shaft repair - by dixierat - 01-19-2009, 08:48 PM
Re: Vernier shaft repair - by exray - 01-20-2009, 04:10 AM
Re: Vernier shaft repair - by dixierat - 01-20-2009, 07:14 PM
Re: Vernier shaft repair - by BDM - 01-20-2009, 08:35 PM
Re: Vernier shaft repair - by dixierat - 01-20-2009, 09:19 PM
Re: Vernier shaft repair - by BDM - 01-20-2009, 10:03 PM
Re: Vernier shaft repair - by dixierat - 01-20-2009, 10:35 PM
Re: Vernier shaft repair - by exray - 01-20-2009, 10:40 PM
Re: Vernier shaft repair - by BDM - 01-20-2009, 10:54 PM
Re: Vernier shaft repair - by dixierat - 01-21-2009, 10:16 PM
Re: Vernier shaft repair - by Texasrocker - 01-21-2009, 11:30 PM
Re: Vernier shaft repair - by exray - 01-22-2009, 05:36 AM
Re: Vernier shaft repair - by dixierat - 01-22-2009, 07:43 PM
Re: Vernier shaft repair - by Texasrocker - 01-23-2009, 02:53 AM
Re: Vernier shaft repair - by dixierat - 01-23-2009, 09:03 PM
Users browsing this thread: 1 Guest(s) |
