07-26-2014, 04:08 PM
I am trying to repair the cracked curved veneer on the top of my Philco 37 116. This is a typical problem on these cabinets.
I would like the veneer to open up enough so I can get some glue inside. Right now it is too tight to the cabinet to get glue under it. If I could lift it a bit that could work well.
Does anyone have a method to do this?
I welcome any ideas you may have.
Thanks,
Steve
I would like the veneer to open up enough so I can get some glue inside. Right now it is too tight to the cabinet to get glue under it. If I could lift it a bit that could work well.
Does anyone have a method to do this?
I welcome any ideas you may have.
Thanks,
Steve
