1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Rubber Chassis Bits....
Robbie Roberts
Member
***
Posts: 147
Threads: 28
Joined: Nov 2005
#1

12-01-2005, 05:24 PM
I have been scouering both great Philco sites, looking for the answer, but haven't found it yet... Does anyone have a source for the rubber bits which support/mount the RF subchassis to the main chassis for the 37-650? I am referring to the two(one each side) which support the front of the subchassis, and are roughly top-hat shaped, and the one into which the tuning condensor unit goes at the back.(also top-hat shaped)

Mine are expired, and I have a few ideas on some alternate replacements, but I wanted to see if anyone else had a source for good repro's or such...

I am not worried about the flat chassis to cabinet washers- I found them easily.

Thanks!
Scott
Old Cars, Old Radios, Old Pipes and Young Women... What more is there?
Find
« Next Oldest | Next Newest »


Messages In This Thread
Rubber Chassis Bits.... - by Robbie Roberts - 12-01-2005, 05:24 PM
[No subject] - by Bill Hutchinson - 12-01-2005, 06:42 PM
Bits Reply - by Robbie Roberts - 12-01-2005, 06:52 PM
Rubber pieces - by Guest - 12-01-2005, 10:27 PM
Rubber Bits - by Robbie Roberts - 12-02-2005, 07:12 AM



Users browsing this thread: 1 Guest(s)
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration