Philco 41-280? Is it worth it?

Register

Guest Join Us

Hello Guest,

Please feel free to join us!
There are many more parts of the Phorum that only members can see.

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Philco 41-280? Is it worth it?

ccomer1955
Senior Member

Posts: 264
Threads: 51
Joined: Aug 2014
City: San Antonio, TX

#16

08-05-2015, 06:37 PM

I will read up on curving veneer, then. I do have an ambition to make this one a learning piece since it's low stakes .

Charlie in San Antonio

Find

« Next Oldest | Next Newest »

Messages In This Thread

Philco 41-280? Is it worth it? - by ccomer1955 - 08-03-2015, 01:49 PM

RE: Philco 41-280? Is it worth it? - by ccomer1955 - 08-03-2015, 02:39 PM

RE: Philco 41-280? Is it worth it? - by murf - 08-04-2015, 06:56 PM

RE: Philco 41-280? Is it worth it? - by mikethedruid - 08-03-2015, 03:06 PM

RE: Philco 41-280? Is it worth it? - by KCMike - 08-03-2015, 03:06 PM

RE: Philco 41-280? Is it worth it? - by ccomer1955 - 08-03-2015, 03:33 PM

RE: Philco 41-280? Is it worth it? - by Arran - 08-04-2015, 02:52 AM

RE: Philco 41-280? Is it worth it? - by Groundhog74 - 08-04-2015, 06:08 AM

RE: Philco 41-280? Is it worth it? - by ccomer1955 - 08-04-2015, 09:47 AM

RE: Philco 41-280? Is it worth it? - by Arran - 08-04-2015, 11:10 PM

RE: Philco 41-280? Is it worth it? - by Radioroslyn - 08-04-2015, 05:13 PM

RE: Philco 41-280? Is it worth it? - by ccomer1955 - 08-04-2015, 06:23 PM

RE: Philco 41-280? Is it worth it? - by Groundhog74 - 08-04-2015, 08:07 PM

RE: Philco 41-280? Is it worth it? - by ccomer1955 - 08-04-2015, 08:41 PM

RE: Philco 41-280? Is it worth it? - by Groundhog74 - 08-05-2015, 06:11 AM

RE: Philco 41-280? Is it worth it? - by ccomer1955 - 08-05-2015, 06:37 PM

RE: Philco 41-280? Is it worth it? - by Warren - 08-06-2015, 12:13 AM

RE: Philco 41-280? Is it worth it? - by Groundhog74 - 08-06-2015, 08:57 AM

RE: Philco 41-280? Is it worth it? - by sam - 08-06-2015, 11:02 AM

RE: Philco 41-280? Is it worth it? - by ccomer1955 - 09-05-2015, 08:06 PM

View a Printable Version

Users browsing this thread: 1 Guest(s)