Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 37-611
#16

Steve do you have a signal generator? If so you could try putting a 470kc mod. signal in the IF stage then det./ocs stage moving backwards toward the antenna connection to see where you lose it.
I assume you have checked all the tubes and I would also clean the band switch very well.
Did you have an antenna hooked up? Just throwing out some ideas you could try. I'm by far no expert on these radios.
There are guys and at least one gal ,Brenda ,on here that probably have forgot more than I will ever know about this hobby.
Good luck


Messages In This Thread
Philco 37-611 - by thinktreasure - 08-05-2015, 09:28 AM
RE: Philco 37-611 - by KCMike - 08-05-2015, 11:53 AM
RE: Philco 37-611 - by thinktreasure - 08-05-2015, 12:16 PM
RE: Philco 37-611 - by KCMike - 08-05-2015, 12:51 PM
RE: Philco 37-611 - by thinktreasure - 08-05-2015, 07:30 PM
RE: Philco 37-611 - by sam - 08-05-2015, 01:02 PM
RE: Philco 37-611 - by thinktreasure - 08-05-2015, 07:06 PM
RE: Philco 37-611 - by tab10672 - 08-05-2015, 05:24 PM
RE: Philco 37-611 - by thinktreasure - 08-05-2015, 07:33 PM
RE: Philco 37-611 - by Radioroslyn - 08-05-2015, 06:18 PM
RE: Philco 37-611 - by tab10672 - 08-05-2015, 07:31 PM
RE: Philco 37-611 - by tab10672 - 08-05-2015, 09:28 PM
RE: Philco 37-611 - by thinktreasure - 08-06-2015, 01:17 AM
RE: Philco 37-611 - by sam - 08-06-2015, 02:25 AM
RE: Philco 37-611 - by thinktreasure - 08-06-2015, 07:30 AM
RE: Philco 37-611 - by KCMike - 08-06-2015, 11:07 AM
RE: Philco 37-611 - by thinktreasure - 08-14-2015, 07:58 AM
RE: Philco 37-611 - by morzh - 08-14-2015, 09:08 AM



Users browsing this thread: 1 Guest(s)