Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 46-350 portable
#16

I restored one a couple years ago.  One of the Candohm resistors was open so I removed the wire from inside and replaced with high wattage resistors. The handle can be bought online for about $25+ and I believe this is one that uses brass split rivets as fasteners. If not, then it will be fastened with threaded brass studs and nuts. I used a zener diode on the filament string as a safety precaution.

Rod


Messages In This Thread
Philco 46-350 portable - by ccomer1955 - 08-14-2015, 08:06 PM
RE: Philco 46-350 portable - by klondike98 - 08-14-2015, 08:47 PM
RE: Philco 46-350 portable - by ccomer1955 - 08-14-2015, 08:51 PM
RE: Philco 46-350 portable - by Radioroslyn - 08-14-2015, 09:31 PM
RE: Philco 46-350 portable - by sam - 08-15-2015, 12:25 PM
RE: Philco 46-350 portable - by codefox1 - 08-15-2015, 08:09 PM
RE: Philco 46-350 portable - by Ron Ramirez - 08-16-2015, 07:07 AM
RE: Philco 46-350 portable - by Radioroslyn - 08-16-2015, 07:39 AM
RE: Philco 46-350 portable - by ccomer1955 - 08-16-2015, 08:43 AM
RE: Philco 46-350 portable - by Arran - 08-17-2015, 11:22 PM
RE: Philco 46-350 portable - by Raleigh - 08-18-2015, 01:34 PM
RE: Philco 46-350 portable - by ccomer1955 - 08-18-2015, 05:23 PM
RE: Philco 46-350 portable - by codefox1 - 08-20-2015, 12:23 PM
RE: Philco 46-350 portable - by Paul Philco322 - 08-20-2015, 08:23 PM
RE: Philco 46-350 portable - by Terry Bills - 04-01-2020, 10:27 PM
RE: Philco 46-350 portable - by RodB - 04-02-2020, 09:42 AM
RE: Philco 46-350 portable - by klondike98 - 04-02-2020, 10:53 AM
RE: Philco 46-350 portable - by RodB - 04-02-2020, 11:34 AM
RE: Philco 46-350 portable - by radiodale - 05-31-2020, 09:28 PM
RE: Philco 46-350 portable - by 462ron - 06-01-2020, 06:24 AM
RE: Philco 46-350 portable - by W7FDR - 11-26-2020, 01:36 PM
Q5 - by nash - 12-17-2020, 01:06 AM
RE: Philco 46-350 portable - by SRv2 - 04-04-2024, 02:13 PM
RE: Philco 46-350 portable - by SRv2 - 04-06-2024, 07:23 PM



Users browsing this thread: 1 Guest(s)