|
Philco Model 89/19 Restoration - Tickler Coil
02-15-2017, 09:40 AM
(02-16-2016, 01:33 PM)Hugh C Wrote: What do you recommend I use as an insulator between the two coils? For an insulator, I just used scotch frosted tape. I lay in on backwards with the sticky side out. This holds the wire in place as I wrap each turn. In order to hold the tape in place, I tape it down with some tiny pieces of additional tape around the perimeter. Mark K8KZ
« Next Oldest | Next Newest »
Messages In This Thread
Philco Model 89/19 Restoration - Tickler Coil - by markmokris - 12-26-2015, 10:58 AM
RE: Philco Model 89/19 Restoration - Tickler Coil - by mikethedruid - 12-26-2015, 08:40 PM
RE: Philco Model 89/19 Restoration - Tickler Coil - by Steve Davis - 12-26-2015, 10:19 PM
RE: Philco Model 89/19 Restoration - Tickler Coil - by Hugh C - 02-16-2016, 01:33 PM
RE: Philco Model 89/19 Restoration - Tickler Coil - by markmokris - 02-15-2017, 09:40 AM
RE: Philco Model 89/19 Restoration - Tickler Coil - by klondike98 - 02-16-2016, 02:39 PM
RE: Philco Model 89/19 Restoration - Tickler Coil - by RadioDR401 - 04-26-2017, 03:24 PM
RE: Philco Model 89/19 Restoration - Tickler Coil - by markmokris - 04-28-2017, 05:38 AM
RE: Philco Model 89/19 Restoration - Tickler Coil - by RadioDR401 - 04-28-2017, 08:43 AM
RE: Philco Model 89/19 Restoration - Tickler Coil - by markmokris - 04-29-2017, 08:43 PM
Users browsing this thread: 1 Guest(s) |
