|
Philco 90 Dial movement
10-02-2008, 02:21 PM
After restoiration, my Philco 90 works very well. However, the dial is a little slippery. This is because the rubber roler that makes it turn is worn. I tried to adjust it, but it continues to slip a little sometimes, especially near the lower frequency end. Is there any paint or rubber coating I could use to make the metal wheel adjust better to the rubber shaft?
Thanks 
« Next Oldest | Next Newest »
Messages In This Thread
Philco 90 Dial movement - by Guest - 10-02-2008, 02:21 PM
Re: Philco 90 Dial movement - by Chuck Schwark - 10-02-2008, 02:39 PM
Re: Philco 90 Dial movement - by etech - 10-12-2008, 10:01 AM
Re: Philco 90 Dial movement - by Ron Ramirez - 10-12-2008, 10:10 AM
Re: Philco 90 Dial movement - by etech - 10-12-2008, 06:50 PM
Re: Philco 90 Dial movement - by Ron Ramirez - 10-12-2008, 09:35 PM
Re: Philco 90 Dial movement - by Guest - 10-13-2008, 06:23 AM
Re: Philco 90 Dial movement - by etech - 10-13-2008, 07:26 AM
Re: Philco 90 Dial movement - by Ron Ramirez - 10-13-2008, 06:06 PM
Re: Philco 90 Dial movement - by Tim Tress - 11-13-2008, 08:14 PM
Users browsing this thread: 1 Guest(s) |
