05-26-2016, 06:03 PM
I am nearing the end of the under-chassis work on my 95. The last thing I have to do is to replace the capacitors in the condenser box (item 48 ). I disconnected all of the wires and removed the box from the chassis. It isn't clear to me how to open up this box. Here is a picture:
https://www.flickr.com/photos/104710683@...ed-public/
As you can see, there is a flange that wraps up from the bottom and extends about a half inch or so. There is one of these on the opposite side as well. Do I need to bend these away from the side? Then what? Give it some heat from the heat gun and pull it apart?
Anything else I need to do?
Thanks in advance.
https://www.flickr.com/photos/104710683@...ed-public/
As you can see, there is a flange that wraps up from the bottom and extends about a half inch or so. There is one of these on the opposite side as well. Do I need to bend these away from the side? Then what? Give it some heat from the heat gun and pull it apart?
Anything else I need to do?
Thanks in advance.
