|
Philco 37-650
08-06-2016, 09:22 PM
I'm new to this site. I need help on locating the on/off, tone control pot for this Philco model. The tone portion is not working properly and the on/off metal piece is fatigued. After changing electrolytics, it still draws too much current. It'll play fine at 110 volts. House current is usually 123. Any suggestions or should I install a limiting resistor? Thanks
« Next Oldest | Next Newest »
Messages In This Thread
Philco 37-650 - by Oldresistor47 - 08-06-2016, 09:22 PM
RE: Philco 37-650 - by Radioroslyn - 08-07-2016, 07:53 AM
RE: Philco 37-650 - by klondike98 - 08-07-2016, 09:14 AM
RE: Philco 37-650 - by Oldresistor47 - 08-07-2016, 05:02 PM
RE: Philco 37-650 - by Radioroslyn - 08-08-2016, 06:23 PM
RE: Philco 37-650 - by Oldresistor47 - 08-07-2016, 05:06 PM
RE: Philco 37-650 - by morzh - 08-07-2016, 05:30 PM
RE: Philco 37-650 - by Oldresistor47 - 08-07-2016, 06:26 PM
RE: Philco 37-650 - by morzh - 08-07-2016, 07:32 PM
RE: Philco 37-650 - by Oldresistor47 - 08-08-2016, 06:24 AM
RE: Philco 37-650 - by Oldresistor47 - 08-08-2017, 05:46 PM
RE: Philco 37-650 - by Oldresistor47 - 08-17-2017, 08:06 PM
RE: Philco 37-650 - by Radioroslyn - 08-17-2017, 09:10 PM
RE: Philco 37-650 - by Oldresistor47 - 08-18-2017, 04:31 AM
RE: Philco 37-650 - by Radioroslyn - 08-18-2017, 10:51 AM
RE: Philco 37-650 - by Oldresistor47 - 08-18-2017, 08:31 PM
RE: Philco 37-650 - by Oldresistor47 - 01-09-2018, 09:34 PM
RE: Philco 37-650 - by Radioroslyn - 01-09-2018, 09:48 PM
RE: Philco 37-650 - by Oldresistor47 - 01-24-2018, 07:14 AM
Users browsing this thread: 1 Guest(s) |
